MAGNET Field: Occupy Backsight Setup
Concept:

- Set Instrument over the control point
- Measure the instrument height
- Launch MAGNET field
- Connect to instrument
- Set the Prism Rover over the other control point.
- In MAGNET field go to SET UP > Backsight

-
Type:
- Point name for Occupy point (Total Station
- HI Height of Instrument (Total Station)

-
Type:
- Point name for reference point (Prism)
- HR Height of Prism Rover measured to the center of the prism
- Press Next

Review and Measure
- Press Set to measure and to orient your instrument

Done
- Now you are referenced to your project control points.
