When to Reset the RC-5
- When the RC-5 will not pair with a total station
- When Bluetooth communication is problematic
What does the Reset do?
- Initializes the Bluetooth module
- Returns all parameters to default settings
- Resets pairing
Prepare to Reset the RC-5
- Insert a fully charged battery in the RC-5
- Clean the RC-5 Laser Projection Port from dust or dirt
- Verify the Bluetooth antenna is secure
- Bluetooth Antenna
- Battery Cover
- Laser Projection Port
Resetting the RC-5
- Hold the FAR and SEARCH buttons
- Press and release the POWER button
- Continue holding the FAR and SEARCH buttons for 10 seconds
- When beep sounds 3 times release both the FAR and SEARCH buttons
- Press and hold the FAR button for 10 seconds or until several beeps are sounded and release
- The COM 1 and COM 2 LEDs will be lit and the FAR and Search LEDs will blink while the reset is perfomed
- When the reset is complete the RC-5 will beep several times followed by a short pause and a single beep
- COM 1 LED for total station communication
- COM 2 LED for data controller communication
- POWER LED
- POWER button
- SEARCH button
- SEARCH LED
- FAR button
- FAR LED
- When the reset is complete
- Power the unit off
- Power on and complete the pairing procedure
* for instrument settings please refer to the instrument's Operators Manual